Recording - Yamaha HTR-5790 Owner's Manual

RECORDING

Recording adjustments and other operations are
performed from the recording components. Refer to the
operation instructions for those components.
STANDBY
/ON
PRESET/TUNING FM/AM A/B/C/D/E
OPTIMIZER
EDIT
MIC
PROGRAM
PHONES SPEAKERS
A B
STRAIGHT TONE CONTROL
EFFECT
SILENT CINEMA
1
1
Turn on the power of this unit and all
connected components.
2
Select the source component you want to
record from.
INPUT
or
Front panel
3
Start playback (or select a broadcast station)
on the source component.
4
Start recording on the recording component.
40
RECORDING
VOLUME
PRESET/TUNING MEMORY TUNING MODE
MAN'L/AUTO FM AUTO/MAN'L MONO
INPUT
VIDEO AUX
INPUT MODE MULTI CH
INPUT
S VIDEO VIDEO L AUDIO R OPTICAL
(U.S.A. model)
2
PHONO TUNER CD MULTI CH IN
V - AUX
CBL/SAT MD/TAPE CD-R
DTV VCR 1 DVR/VCR2 DVD
Remote control
Notes
• Do a test recording before you start an actual recording.
• When this unit is set in the standby mode, you cannot record
between other components connected to this unit.
• The setting of TONE CONTROL, VOLUME, "Speaker level"
(page 50) and programs does not affect the recorded material.
• A source connected to the MULTI CH INPUT jacks of this unit
cannot be recorded.
• S-video and composite video signals pass independently
through this unit's video circuits. Therefore, when recording or
dubbing video signals, if your video source component is
connected to provide only an S-video (or only a composite
video) signal, you can record only an S-video (or only a
composite video) signal to your VCR.
• A given input source is not output on the same REC OUT
channel. (For example, the signal input from VCR 1 IN is not
output on VCR 1 OUT.)
• Check the copyright laws in your country to record from
records, CDs, radio, etc. Recording of copyrighted material may
infringe copyright laws.
If you playback a video source that uses scrambled or
encoded signals to prevent it from being dubbed, the
picture itself may be disturbed due to those signals.
Special considerations when recording
DTS software
The DTS signal is a digital bitstream. Attempting to
digitally record the DTS bitstream will result in noise
being recorded. Therefore, if you want to use this unit to
record sources that have DTS signals recorded on them,
the following considerations and adjustments need to be
made.
For LDs, DVDs and CDs encoded with DTS, when your
player is compatible with the DTS format, follow its
operation instruction to make a setting so that the analog
signal will be output from the player.