Speaker Impedance Setting; Turning On The Power - Yamaha HTR-5790 Owner's Manual

Speaker impedance setting

CAUTION
If you are using 6 ohm speakers, set the impedance to 6
ohms as follows before turning on the power.
Be sure this unit is in the standby mode.
1
On the front panel, while pressing down
SPEAKERS A, press STANDBY/ON.
"SP IMP.SET" appears on the front panel display for
a few seconds, then "Minimum 8ohms" appears.
SPEAKERS
A
S P I M P . S E T
M i n i m u m 8 o h m s
2
Press SPEAKERS A or SPEAKERS B to
select the impedance of your speakers.
You can select either 6 ohms or 8 ohms.
3
Press STANDBY/ON to exit the setting.
This unit will be set to the standby mode.
y
You can also use SP IMP.SET (see page 57) to set the speaker
impedance.
When all connections are complete, turn on the power of
this unit.
1
STANDBY
/ON
1
2

Turning on the power

STANDBY
/ON
PRESET/TUNING FM/AM A/B/C/D/E
OPTIMIZER
EDIT
MIC
PROGRAM
PHONES SPEAKERS
A B STRAIGHT TONE CONTROL
EFFECT
SILENT CINEMA
TRANSMIT
SYSTEM
POWER STANDBY
1
PHONO TUNER
V-AUX CBL/SAT
DTV VCR 1
POWER
TV
REC
Press STANDBY/ON (SYSTEM POWER on
the remote control) to turn on the power of
this unit.
STANDBY
/ON
Front panel
Turn on the video monitor connected to this
unit.
CONNECTIONS
VOLUME
PRESET/TUNING MEMORY TUNING MODE
MAN'L/AUTO FM AUTO/MAN'L MONO
INPUT
VIDEO AUX
INPUT MODE MULTI CH
INPUT
S VIDEO VIDEO L AUDIO R OPTICAL
(U.S.A. model)
RE–NAME CLEAR LEARN
SLEEP INPUT MODE
CD MULTI CH IN
MD/TAPE CD-R
DVR/VCR2 DVD
SELECT
POWER
AMP
AV
SYSTEM
POWER
or
Remote control
23