Yamaha DSP-AX463 Owner's Manual page 70

Troubleshooting
After AUTO SETUP
Warning message
W-1:OUT OF PHASE
W-2:OVER 24m (80ft)
W-3:LEVEL ERROR
Notes
• If the "ERROR" or "WARNING" screens appears, check the cause of the problem, then run "AUTO SETUP" again.
• If a warning message "W-1", "W-2", or "W-3" appears, corrections are made, but they may not be optimal.
• If an error message "E-9" occurs repeatedly, please contact a qualified Yamaha service center.
68
En
Cause
Speaker polarity is not correct. This
message may appear depending on the
speakers even when the speakers are
connected correctly.
The distance between the nearest speaker
and the furthest speaker is out of adjustable
range.
The difference of volume level among
speakers is excessive. (No level correction
is made.)
Remedy
Check the speaker connections for proper
polarity (+ or –).
Bring the speaker closer to the listening
position.
If "SWFR:TOO LOUD" or "SWFR:TOO
LOW" appears, adjust the output volume of
the subwoofer.
Readjust the speaker installation so that all
speakers are set in locations with similar
conditions.
Check the speaker connections.
Use speakers of similar quality.
See
page
12
—
23, 52
—
11
—