Control Panel; Rear; Base; Remote Control - Yamaha LPX-500 Owner's Manual

Rear

TRIGGER OUT port
When the projector power is turned
on, 12 V DC is output from this
port. When the projector's power is
turned off, the output becomes 0 V
to communicate the projector's
power ON/OFF status to an
external device.
Remote control light-
receiving area
(Setup Guide)
Receives signals from
the remote control.
Main power switch
(p.6)
Press to turn the main
projector's power on
and off. When the power
is off, the power
consumption is 0 W.
Rear adjustable foot
Extend and retract to
adjust the horizontal
projection angle.
Power inlet (p.6)
Connects the power
cord.

Base

Front adjustable foot
Rear adjustable foot
Suspension bracket fixing points (4 points) (p.51, Setup Guide)
Install the optional ceiling mount here when suspending the projector from the
ceiling.
INPUT A port (Setup Guide)
Inputs component video
and RGB video signals from other
video sources.
VIDEO port
(Setup Guide)
Inputs composite video signals to
the projector from other video sources.
Air filter (air inlet) (p.46, 50)
Prevents dust and other foreign particles from being drawn into the projector.
When replacing the lamp, replace the air filter also.
Front/Top

Rear

Remote control

Control panel

Base

RS-232C port
Connects the projector to a computer using an
RS-232C cable.
This port is for service use, and should not
normally be used.
D4 VIDEO port (Setup Guide)
Inputs component video signals from D ports of
AV equipment.other video sources.
INPUT B port (Setup Guide)
Inputs analog RGB video signals from a
computer, and component video
RGB video signals from other video sources.
DVI port (Setup Guide)
Inputs digital RGB video signals from
a computer.
Rear adjustable foot
signals
Extend and retract to
adjust the horizontal
projection angle.
S VIDEO port (Setup Guide)
Inputs an S-Video signal to the
projector from other video sources.
Rear adjustable foot
signals and
59