3-1-10: MC3 ENABLE / 3-1-11: MC4 ENABLE
[PLAY MODE] -> PFM PLAY -> [EDIT/COMPARE] -> 3: Full Edit -> [ENTER] -> 3-1:Layer -> [ENTER]
-> [PAGE] -> 3-1-10 : MC3 Enable -> [ENTER]
3-1-11 : MC4 Enable -> [ENTER]
MIDI control change data received by the TG500 can be used to control the level
of individual layers or specified groups of layers in the performance play mode. This
screen specifies which MIDI control device (assigned via the "UTILITY" mode
"2:Controller" screen) controls which layers.
The layer to be edited can be selected as described on page 50. The currently
selected layer is shown in square brackets on the upper display line.
MC3 (MIDI controller 3 enable)
PERFORMANCE EDIT MODE / 3: Full Edit. 3-1: Layer
PFM MC3 [A] WN Flut1
n
o
ÿ onÿ onÿ onÿ
MC3 (layer A)
PFM MC4 [A] WN Flut1
n
o
ÿ offÿ offÿ onÿ
MC4 (layer A)
Range: on, off
,
.
Use the [
] and [
the layer to be edited, then use the [-1/NO] and [+1/YES] keys to turn MIDI
control of that layer on or off.
The name of the currently selected voice is shown in the upper right corner
of the display ("--------" appears if the voice is turned off). An animated musi-
cal note appears to the right of voices that are on and active (i.e. not muted).
3-1-10: MC3 ENABLE / 3-1-11: MC4 ENABLE
] keys (or the standard layer selection procedure) to select
71