Installation Of The Syemb06 Expansion Memory Board - Yamaha TG500 Owner's Manual

Appendix
Installation of the SYEMB06
Expansion Memory Board
1
disconnect the AC power cord from the
main outlet.
2
the TG500 and remove the two screws that
hold it in place (Figure 1).
3
panel (Figure 2). When installing a single
SYEMB06 use slot number 1. Install a
second SYEMB06 in slot number 2.
4
screws you removed in step 2.
The wave memory must be initialized after installation of the SYEMB06.
WARNING: Installation of a SYEMB06 may cause the internal data to be damaged.
282 EFFECTS

Installation of the SYEMB06 Expansion Memory Board

Turn the TG500 power switch off and
Locate the small cover on the top of
Below the cover you will see a recessed
Replace the cover and secure it with the
Figure 1
Figure 2
Backup the internal data before installation.