Yamaha TG500 Owner's Manual page 41

3-2
Press [ENTER], then use the [-1/NO] and [+1/YES] keys to select the "3-
1:Layer" screen.
É
PFM EDIT
3-1:Layer
When you've located this screen, press [ENTER] to engage the performance
edit "Layer" mode.
4
Select the Voices for Each Layer
If the "PFM Voice" display doesn't appear as soon as you engage the
performance layer mode, press [PAGE], use the [-1/NO] and [+1/YES] keys to
select the "3-1-01:Voice" screen, then press [ENTER].
PFM Voice [A] AP Grand
É É
00‹ 00‹
The voice numbers assigned to each layer are shown across the bottom of
,
the display. After initialization, voice "P
Use the [ ] key to place the underline cursor under the layer-A voice
number (note that the selected layer is shown in square brackets and the voice
name is shown in the upper right corner of the display), then use the [-1/NO]
and [+1/YES] keys to select voice number "P .
Next press the [ ] key to select the layer-B voice number, and use the
.
[-1/NO] and [+1/YES] keys to select voice number "P
Next press the [ ] key to select the layer-C voice number, and select voice
number "P 21" (ST Pizz).
IV
Finally, move the cursor to the layer-D voice number and, while holding
the [UTILITY/SELECT] key, press the [MEMORY] key to turn layer-D "off"
(page 50).
PFM Voice [A] BA Wood
É É
06‹ 04‹ Ü21‹ off
00œ:InitPerf
É É
00‹ 00‹
00" is assigned to all four layers.
I
06" (BA Wood).
I
04" (AP Tack).
I
3. The Performance Mode
29