Before You Use The Handi-Lift; Sketch Of All The Positions - Cama Handi-Lift 7 Handbook

Handi-lift 7
At the lift installation a main power switch is installed, where the power to the lift can be
cut off. The main power switch is only used during lift maintenance. There has to be light
(min. 50 lux), where the lift is used, and when maintenance of the lift is made.
Furthermore a socket has to be available near the lift installation.

1.4 Before you use the Handi-lift:

The lift is equipped with various safety features, which must be tested before you use
the lift. If the safety features do not work, you cannot use the lift and you shall contact
your maintenance company.
Please note that you shall drive on the lift with the front downward. Remember to brake
the lift.
As user of the lift you need to note if the functions described below works as they should,
however it is the installer's task to check the functions during the installation and during
the regular maintenance inspections on the lift.
Check that upper and lower barrier arm (pos 1 and 2 on the sketch in section 1.2) moves
as they shall. Lower barrier arm may not open at landings, as it shall prevent the user
from driving off the lift in that direction.
Check upper and lower flap on the platform (pos 3, 4 and 5 on the sketch in section 1.2).
Touching the upper flap while the lift is driving up and the lower flap while the lift is
driving down checks the flaps on the platform. The lift shall stop automatically when the
flaps are touched, and it cannot drive again until the obstacle is removed. Touching the
platforms under plate when the lift is driving down the stairs shall also stop the lift
automatically and first when the obstacle is removed can the lift drive again.

Sketch of all the positions:

The sketch below shows the Handi-lift in the various positions it can be in. The sketches
show a left hand lift.
© 2010 Page 6 Version 1.0