Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Cama Handi-Lift 7
Summary of Contents for Cama Handi-Lift 7
- Page 1 Handbook for Handi-Lift 7 CAMA Lift Aps. Ellehammervej 6 DK – 9900 Frederikshavn...
- Page 2 Handi-lift 7 Version 1.0 OPERATION MANUAL FOR HANDI-LIFT 7 © 2010 Page 1 Version 1.0...
- Page 3 Handi-lift 7 Index Introduction Congratulations with your new CAMA Handi-Lift: Sketch of Handi-lift EA7: Generally about the lift: Before you use the Handi-lift: Operation of Handi-Lift EA7 Operation from the lifts control panel: 2.1.1 Emergency stop: 2.1.2 Joystick: 2.1.3 Connection for remote control with spiral wire: 2.1.4...
- Page 4 Handi-lift 7 Emergency lowering Emergency raise of the barrier arms: Emergency raise of the platform: Emergency lowering of the lift: Extra equipment Side-access-ramp: Fold down seat: Alarm/emergency call: Emergency release: Flash light: Rain cover: Light and sound: Vandal proof barrier arms:...
- Page 5 Thank you for choosing a CAMA Handi-Lift. Please read the instructions carefully before using the lift. Your CAMA Handi-Lift has been built with careful attention to detail. In order to obtain many years of trouble free use, please follow the instructions with special attention to the care and maintenance requirements.
- Page 6 Handi-lift 7 1.3 Generally about the lift: Type EA7 is a fully-automatic lift, where the user does not have to operate anything manually, all operations are electrically controlled. The Handi-Lift consists of a rail in aluminium and a lift carriage with foldable platform.
- Page 7 Handi-lift 7 At the lift installation a main power switch is installed, where the power to the lift can be cut off. The main power switch is only used during lift maintenance. There has to be light (min. 50 lux), where the lift is used, and when maintenance of the lift is made.
- Page 8 Handi-lift 7 Handi-lift in parked position. Handi-lift ready for use at the bottom of the stair. Handi-lift when driving. Handi-lift at landing at the top of the stairs. © 2010 Page 7 Version 1.0...
- Page 9 Handi-lift 7 2 Operation of Handi-Lift EA7 2.1 Operation from the lifts control panel: 20) Emergency stop 21) Joystick 22) *Connection for remote control with spiral wire 23) Emergency call 24) Light diode 25) *Key lock * Extra equipment (not standard on all lifts).
- Page 10 Handi-lift 7 2.1.2 Joystick: You use the joystick, (pos 2 on above sketch) on the Handi-Lift by pushing the joystick in the direction you wish to drive. The Hand-lift stops automatically when it reaches the end of the stairs or a landing.
- Page 11 Handi-lift 7 2.2 Operation from control box on wall or column: 1. Up 2. Down 3. Open 4. Close 5. Key lock 6. Green light diode The control boxes can vary in look, but the symbols for the functions are the same on all type of boxes.
- Page 12 Handi-lift 7 boxes with battery supply the green light will first be lit when one of the buttons is pushed. The key lock will only lock the control box in question. The control box uses 3 AA batteries and these will be replaced during maintenance or when needed.
- Page 13 Handi-lift 7 The key lock (pos 5 on sketch in section 2.2) is used to lock the control box and only this control box. By turning the key you will turn on the power supply to the control box. The control box is turned on when the key is horizontal.
- Page 14 Handi-lift 7 sketch in section 2.1); please observe that the guide pins on the plug fits, when you insert the plug. 2.3.1 Up: Push the Up-button down and hold it down (pos 1 on sketch above), this will make the lift drive up.
- Page 15 Handi-lift 7 2.4.1 Up: The up-button (Pos 1 on the above sketch) is used to drive the lift up the stairs, push the button down and hold it down to get the lift to drive. If you let go of the button when driving, you will have to wait a couple of seconds before the button can activate the lift again.
- Page 16 Handi-lift 7 3.1 Emergency raise of the barrier arms: Remove the rubber plug on the lifts front cover. (pos 16 and 17 on the sketch in section 1.2); put the screwdriver in the hole for the barrier arm you which to raise. Push the screwdriver all the way in to release the barrier arm.
- Page 17 Handi-lift 7 4 Extra equipment 4.1 Side-access-ramp: The side-access-ramp (pos 6 on sketch in section 1.2) is only used when there is a specific wish or when there is not enough room to drive off the lift at the bottom of the stairs.
- Page 18 Handi-lift 7 Warning! Never emergency lower the lift, if there is a person or an object on the platform. Never try to emergency lower the lift up or down if the lifts drop lock is activated. Contact the dealer immediately. We do not recommend that emergency lowering is carried out be others than the technicians of your dealers company.
- Page 19 Handi-lift 7 5 What to do if your lift fails to operate If the schedule below does not solve the problem, please contact your maintenance company. Symptom Cause Solution The lift will not start Disconnected on the safety Turn on the safety switch...
- Page 20 Handi-lift 7 bottom position maintenance department if the (only valid at fully obstacle is difficult to remove automatic lifts) Lift stops between Fuses in main power board Change fuses or activate RCCB- the landings or RCCB-relay relay Upper or lower ramp limit...
- Page 21 Handi-lift 7 7 Service The Handi-Lift is delivered mounted and tested by trained and by Cama authorised personnel. The number of examinations of the lift per year depends on the law in your country, however Cama recommends that the Handi-Lift is examined minimum once a year.