Husqvarna R 419TsX AWD Operator's Manual page 28

2. Remove the 3 screws that hold the BioClip plug and
remove the plug.
3. Attach 3 M8x15 mm screws in the screw holes for
the BioClip plug to prevent damage to the threads.
4. Put the cutting deck in the mow position.
5. Attach the BioClip plug in the opposite sequence.
To examine the blades
CAUTION: Damaged or incorrectly balanced
blades can cause damage to the product.
Replace damaged blades. Let an approved
service agent help you sharpen and balance
blunt blades.
1. Put the cutting deck in servicing position.
2. Look at the blades to see if they are damaged and if
it is necessary to sharpen them.
3. Tighten the blade bolts with tightening torque 75-80
Nm.
To replace the blades
1. Put the cutting deck in servicing position.
2. Lock the blade with a wooden block (A).
C
3. Loosen and remove the blade bolt (B), the washers
(C) and the blade (D).
28
B
D
A
4. Assemble the new blade with the ends that have an
angle in the direction of the cutting deck.
WARNING: Incorrect blade type can
cause objects to eject from the cutting
deck and cause serious injury. Use only
the blades given in
page 37 .
5. Attach the blade, the washer and the bolt. Tighten
the bolt with a torque of 75-80 Nm.
To do a check of the engine oil level
1. Park the product on level ground and stop the
engine.
2. Open the engine cover.
3. Loosen the dipstick and pull it out.
4. Clean the oil from the dipstick.
5. Put the dipstick in the hole for the dipstick and
tighten it.
6. Loosen and pull the dipstick out and read the oil
level.
7. The oil level must be between the marks on the
dipstick. If the level is near the ADD mark, fill oil to
the FULL mark.
8. Fill the oil through the hole for the dipstick. Fill the oil
slowly.
Technical data on page 37 for the
Note: Refer to
types of engine oil that we recommend. Do not mix
different types of oil.
Technical data on
880 - 006 - 09.09.2020