Husqvarna R 419TsX AWD Operator's Manual page 27

11. Loosen the locknut (A) on the clevis joint on the
height adjustment stay. Turn the clevis joint (B) on
the height adjustment stay to adjust the length of the
height adjustment stay. Make sure that the clevis
joints align with the correct hole on the frame of the
cutting deck.
Note: The 2 ends of the height adjustment stay each
have a clevis joint. You get the same result
independently of which clevis joint you adjust.
12. Use the middle hole (A) on the frame in the cutting
deck.
13. Tighten the locknuts on the height adjustment stay.
14. Move the cutting height lever to the cutting height
position 1.
15. Remove the right footrest plate. Refer to
and install the right footrest plate on page 21 .
880 - 006 - 09.09.2020
A
B
A
To remove
16. Loosen the locknut (A) on the stretching screw of the
cutting height chain.
17. Turn the adjustment screw (B) on the cutting height
chain until the bearing wheel (C) touches the
lever(D).
C
18. Tighten the locknut on the stretching screw.
19. Do a check of the parallelism. Refer to
check of the parallelism of the cutting deck on page
25 .
20. Attach the right footrest plate.
To remove the BioClip plug
• Remove the BioClip plug to change a Combi cutting
deck from BioClip to rear discharge of the grass.
To remove and attach the BioClip plug on the
cutting deck Combi 103, Combi 112, Combi
122
1. Put the cutting deck in servicing position. Refer to
put the cutting deck in the servicing position on page
25 .
A
B
D
To do a
To
27