Husqvarna R 419TsX AWD Operator's Manual page 17

drive system lever in fully to engage the drive on the
axle. Do not use middle positions.
The product has one drive system lever for the front axle
and one for the rear axle. The drive system lever for the
rear axle is found behind the left rear wheel.
The drive system lever for the front axle is found behind
the left front wheel.
To lift and lower the cutting deck
• To lift the cutting deck to the transport position, pull
the lift lever rearward.
• To lower the cutting deck to the mow position, push
the lift lever forward.
880 - 006 - 09.09.2020
To start the engine
1. Push the PTO button to disengage the drive on the
cutting deck.
2. Apply the parking brake.
3. For R 420TsX AWD: If the engine is cold, move the
choke control fully rearward.
4. Turn the ignition key to the start position.
5. When the engine starts, immediately release the
ignition key to the neutral position.
Note: Do not keep the ignition key in the start
position for more than 5 seconds at a time. If the
engine does not start, wait 15 seconds before you try
again.
17