Octave Change - Yamaha Portatone PSR-5700 Owner's Manual

Transposition, Tuning, and Octave Change
This function allows the ORCH. 1 and ORCH. 2 voices to be independently trans-
posed up or down by one octave.
Z
Press the [OCTAVE CHANGE]
Button

OCTAVE CHANGE

Orc2=Normal
– +
X
Set the Octave Change As
Required
OCTAVE CHANGE
Orc2=Normal
– +
C
Press [EXIT] When Done
FUNCTION
EXIT
1 6
OCTAVE CHANGE
Select the OCTAVE CHANGE function from the normal play mode by
pressing the [OCTAVE CHANGE] button (this is the same as the [>] dis-
play scroll button to the right of the LCD panel).
Orc1=Normal
TRANSPOSE/
TUNE
– +
Use the left [-] and [+] buttons to set the octave of the ORCH. 2 voice,
and the right [-] and [+] buttons to set the octave of the ORCH. 1 voice.
"Normal" on the display indicates that the corresponding voice is set to its
normal octave, "1down" indicates that the voice is shifted down one octave,
and "1up" indicates that the voice is shifted up one octave.
Orc1=Normal
– +
Press the [EXIT] button to exit from the OCTAVE CHANGE function.
DETAIL
IMPORTANT
DETAIL
A. B. C. MODE
s
< >
OCTAVE
CHANGE
t
HARMONY
TYPE
The OCTAVE CHANGE mode is automatically exited if neither of the [-] or [+]
buttons are pressed for approximately 10 seconds.
Some voices may suddenly shift octaves when played at the extreme ends of
the keyboard if they are set to a lower or higher octave than normal. This can
also occur when the PITCH BEND wheel is used on extremely low or high
notes.
If you change the transpose, octave change, or tuning settings while playing
one or more notes on the keyboard, the new transpose and octave change
settings will take effect from the next notes played while tune settings take
effect immediately.