Sfp+ Port - H3C S5830 Series Installation Manual

Transceiver module
SFP-FE-LX-SM1550-BIDI
IMPORTANT:
You must use the SFP-FE-LX-SM1310-BIDI and SFP-FE-LX-SM1550-BIDI transceiver modules in pairs.
For the SFP transceiver module specifications, see H3C Low End Series Ethernet Switches Pluggable
Modules Manual.
NOTE:
• To guarantee the functionality of the SFP ports, use only H3C SFP transceiver modules on the
S5830-52SC switch.
The SFP transceiver modules available for this switch series are subject to change over time. For the most
•
up-to-date list of SFP transceiver modules, consult your H3C sales representative or technical support
engineer.
NOTE:
The SFP ports (numbered 49 and 50) and the last two 10/100/1000Base-T Ethernet ports (numbered 47
and 48) on the S5830-52SC form two combo interfaces. Ports 49 and 47 form one combo interface, and
ports 50 and 48 form another. Only one port in a combo interface can work at a time.

SFP+ port

Every S5830 switch has SFP+ ports, and you can plug the SFP+ transceiver modules, SFP transceiver
modules, and SFP+ cables in
physical ports to connect S5830 switches in an IRF deployment.
Table 18 SFP+ transceiver modules and cables available for the H3C S5830 Switch Series
Transceiver
module/cable
1000 Mbps SFP transceiver modules
SFP-GE-SX-MM850-A
SFP-GE-LX-SM1310-A
SFP-GE-LH40-SM1310
Central
Connector
wavelength
TX: 1550 nm
LC
RX: 1310 nm
Table 18 into the SFP ports as needed. You can use the SFP+ ports as IRF
Central
Connector
wavelength
850 nm LC
1310 nm LC
1310 nm LC
53
Max transmission
Fiber
distance
9/125 μm
single-mode optical 15 km (9.32 miles)
fiber
Max transmission
Fiber
distance
•
50/125 μm
•
multi-mode
optical fiber
• •
62.5/125 μm
multi-mode
optical fiber
9/125 μm
single-mode optical 10 km (6.21 miles)
fiber
9/125 μm
single-mode optical 40 km (24.86 miles)
fiber
550 m (1804.46 ft)
over 50/125 μm fiber
275 m (902.23 ft) over
62.5/125 μm fiber