Applications - Yamaha MX12/6 Owner's Manual

Applications

Example 1) Sound Reinforcement for a live
Monitor Speakers
Power Amplifier
Headphones
C-R/PHONES
GROUP OUT
MTR
Set the POST Switch to "?"
(AUX2=PRE).
Group Select Switches
Channel Faders
Procedure
q Connect line input devices or microphones to the INPUT jacks and connect a power amp, that is
connected to the main speakers, to the ST OUT Jacks.
w Use the GAIN Control on each channel to adjust the level of the input signal from the device or
microphone that is connected to the input channel (refer to page 2), and use the Channel Fader to
adjust the level of the output signal that is sent to the Master Section. Basically, you should set the
Channel Fader close to the "0" position.
e Press each channel's "ST" GROUP Select Switch.
r Use the ST Master Fader to adjust the level of the signal sent to the power amplifier. Basically, you
should set the Master Fader close to their "0" position.
t Use the volume control(s) on the power amp to adjust the volume of the speakers.
If necessary, use a monitoring device (a pair of headphones, monitor speakers, etc.), a recording device,
effector, etc.
performance
Effector
AUX 1 AUX 2 (PRE)
SEND SEND
1 – 4
INPUT
Microphone, Line Input
Main Speakers
Power Amplifier
INSERT I/O ST OUT
GROUP 1-4 Faders
Applications
Sub Woofer, etc.
Power Amplifier
MONO OUT
CD Recorder, DAT, etc.
TAPE IN
REC OUT
EFFECT
SEND
Effector
RETURN
C-R/PHONES Output and Meter Select Switch
ST Master Fader
MX12/6, 20/6 — Owner's Manual
9