Feet; Effect (On/Off); Pan; Brilliance - Yamaha Electone EL-87 Owner's Manual

N O T E :
Each effect may not be noticeable even
though you select the effect here, if the
corresponding settings on the Effect Set
page (See pages 40 and 41) are not
appropriate.
N O T E :
The Pan effect is displayed and active only
when other effects are set to OFF (in the
EFFECT parameter above).
N O T E :
These effects are applied in different
degrees depending on the voice group
you've selected.
38

2 FEET

Determines the octave setting of the voice. PRESET is the original
(factory) setting; 4' is the highest and 16' is the lowest.

3 EFFECT (On/Off)

Determines the effect type applied to the voice section. This is essentially
an on/off switch for the effects; settings and adjustments to the effects
are made from other pages. (For more information, see page 40.)
3 PRESET:
- 1
Selects the original (factory) effect.
- 2 OFF:
3
Cancels the effect.
TREM (TREMOLO):
- 3
3
Selects tremolo/chorus. See page 46 for the details of the tremolo/
chorus setting.
- 4 SYMPH (SYMPHONIC):
3
Selects symphonic/celeste. See page 40 for the details of the
symphonic/celeste setting.
- 5 DELAY:
3
Selects delay. See page 41 for the details of the delay setting.
- 6 FLANG. (FLANGER):
3
Selects flanger. See page 41 for the details of the flanger setting.

4 PAN

Determines the position of the voice in the stereo image. Seven pan
positions are available.
5 BRIL. (BRILLIANCE)
Adjustment of the voice tone. Higher settings make the voice brighter.
(This control is the same as on the panel.) Range: -3- +3
6 VOL. (VOLUME)
Fine adjustment of the voice volume. See page 23 for more information.