Turning The Power On - Yamaha Clavinova CLP-175 Owner's Manual

Before Using the Clavinova

Turning the power on

1. Connect the power cable.
First insert the plug of the power cable into the AC connector on the Clavinova, then plug the other end of
the cable into the proper AC outlet on the wall.
In some areas a plug adaptor may be provided to match the pin configuration of the AC wall outlets in
your area.
1
WARNING!
Make sure your CLP-175 is rated for the AC voltage supplied in the area in which it is to be used (voltage rating appears on the
name plate on the bottom panel). In some areas, a voltage selector may be provided on the bottom panel of the main keyboard
unit near the power cord. Make sure that the voltage selector is set for the voltage in your area. Connecting the unit to the wrong
AC supply can cause serious damage to the internal circuitry and may even pose a shock hazard!
Use only the AC power cord supplied with the CLP-175. If the supplied cord is lost or damaged and needs to be replaced, con-
tact your Yamaha dealer. The use of an inappropriate replacement can pose a fire and shock hazard!
The type of AC power cord provided with the CLP-175 may be different depending on the country in which it is purchased. (In
some areas a plug adaptor may be provided to match the pin configuration of the AC wall outlets in your area.) Do NOT modify
the plug provided with the CLP-175. If the plug will not fit the outlet, have a proper outlet installed by a qualified electrician.
2. Turn on the power to the Clavinova.
Press the [POWER] switch located on the right of the keyboard to turn the power on.
• The screen located in the center of the front panel lights up. The drive
lamp below the lower right end of the keyboard also lights.
When you turn on the power to the Clavinova, a voice name
appears on the screen.
Press the [POWER] switch again to turn off the power to the Clavinova.
• The screen and the drive lamp turn off.
18
CLP-175
The drive lamp lights.
A
C
2
(The shape of plug differs
depending on locale.)
[POWER]
B
NO YES
D
TIP
If you close the key cover
without turning the power
off, the drive lamp remains
lit, indicating that the power
is still on.