Selecting The Steam; Selecting Shot-Steam And Steam When Ironing Vertically; Dry Ironing - Singer SNG 4.23 Operation And Safety Notes

To iron without steam, follow the instructions in section "steam
ironing", leaving the steam selector on position " ".
311270_Singer_Buegeleisen_SNG4.23_content_DE_GB_IE_NI_FR_HU_CZ_SK.indd 25
flicker indicates that the iron is heating up. Wait until the plate
"STANDBY" symbol no flicker before ironing.
during ironing, the plate temperature pilot light
comes on at intervals, indicating that the selected temperature
is maintained. If you lower the thermostat temperature after
ironing at a high temperature, do not start ironing until the
plate temperature control light comes on again.

Selecting the steam

The quantity of steam is regulated by the steam selector.
the iron gives off steam continuously only if
you hold the iron horizontally. You can stop the continuous
steam by placing the iron in a vertical position or by moving
the steam selector to " ". As indicated on the thermostat
knob and in the initial table, you can only use steam at the
highest temperatures. If the selected temperature is too low,
water may drip onto the plate.
Selecting Shot-steam and steam when
ironing vertically
Press the shot-steam button to generate a powerful burst of
steam that can penetrate the fabrics and smooth the most diffi-
cult and tough creases. Wait for a few seconds before press-
ing again (Fig. 4).
By pressing the shot-steam button at intervals you can also
iron vertically (curtains, hung garments, etc.) (Fig. 5).
the shot-steam function can only be used at
high temperatures. Stop the emission when the plate tempera-
ture pilot light comes on, than start ironing again only after the
light has gone off.

Dry ironing

GB/IE/NI 25
31.10.18 14:36