Yamaha AW 16G Owner's Manual page 51

MIC/LINE
INPUT jack
Internal effect
Note Note
If the input channel is paired, the same settings will be
applied to both channels.
7
If you want to adjust the effect, use the
[INPUT SEL] key to select the input channel.
While you produce sound on your instru-
ment, adjust the [EQ] knob, [DYN] knob, or
[EFF 1]/[EFF 2] knobs of the Selected Channel
section.
Immediately after you select an input library, turn-
ing the knobs of the Selected Channel section will
control the following items.
Turning the [EQ] knob ......Adjusts the amount of boost/
Turning the [DYN] knob....Simultaneously adjusts multi-
Turning the [EFF 1] knob...Adjusts the balance of direct
Turning the [EFF 2] knob...Adjusts the balance of direct
Note Note
Depending on the input library you select, the level of
the input channel may change. Re-adjust the volume bal-
ance using the INPUT LEVEL knob in the INPUT SET-
TING popup window.
Tip! Tip!
If turning the [EQ] knob or [DYN] knob does not produce
the desired result, you can reload new settings from the
EQ library or dynamics library ( → p. 77, 78).
8
In the same way, select input library settings
for the other input channels.
However, a maximum of two input channels can
use the internal effects at the same time.
Input library
Speaker
simulator
EQ
Input channel
cut for each EQ band. To select
the band that will be adjusted,
use the [HIGH] key, [HI-MID]
key, [LO-MID] key, or [LOW]
key located at the right.
ple dynamics parameters to
adjust the dynamics effect. The
result will depend on the
library that you selected.
sound and processed sound
for internal effect 1.
sound and processed sound
for internal effect 2.
Dynamics
INPUT LEVEL
to the bus
5
51