Automation
Viewing the Automation Mode
The Automation mode setting of each channel can be viewed as follows.
Press either the [F3] or [F4] button.
1
Channel Display mode or Meter Display mode is selected.
Press and hold a channel's [AUTO] button.
2
The channel's Automation mode is displayed while the [AUTO] button is pressed.
Pro Tools
Auto write
Auto touch
Auto latch
Auto read
Auto off
For MIDI tracks, "—" appears on the display.
The Automation mode settings of all channels can be viewed as follows.
3
Press and hold the USER DEFINED [DISPLAY] (AUTO STATUS) button.
The Automation modes of all channels are displayed while the USER DEFINED [DISPLAY]
(AUTO STATUS) button is pressed.
Setting the Automation Mode
The Automation mode can be set as follows.
While holding down a channel's [AUTO] button, press the USER DEFINED [3]
1
(WRITE), [4] (TOUCH), [5] (LATCH), [6] (READ), [7] (TRIM), or [8] (OFF) but-
ton.
If Channel Display mode or Meter Display mode is currently selected, the channel's Auto-
mation mode is displayed while the [AUTO] button is pressed.
Grouped channels are set together.
Display
Wrt
Flashing red (Record Ready)
Tch
Red (Recording)
Ltch
Read
Green
Off
Off
Automation
[AUTO] Button Indicators
02R96—Owner's Manual
187