General Procedure - Yamaha SU700 Owner's Manual

SAMPLE: Edit/convert the waveform on the selected track.
START POINT
END POINT
PROCESS
TRIM
REVERSE
NORMALIZE
FREQ. CONVERT Reduce the waveform's sampling frequency (freeing up additional waveform memory).
BIT CONVERT
STEREO TO MONO Convert stereo sample to mono (freeing up additional waveform memory).
DELETE
RESAMPLE: Record sample from already recorded track or song.
TRACK
SEQ
DISK: Load to disk, save from disk, and manage disks.
LOAD
SAVE
DELETE
UTILITY
DISK INFO
DISK FORMAT
SYSTEM: Set system and MIDI parameters; check free memory.
SETUP
METRONOME
COUNTDOWN
REC MODE
PAD SENS
AUDIO IN
RIBBON FUNCTION Select the function controlled by the ribbon.
MIDI
SYNC
CHANNELS
CONTROL NUMBERS Set the MIDI control numbers for each song.
SCSI
MEMORY

10.2 General Procedure

To execute a job, you use the following general procedure.
1.
Be sure that the sequencer is in PLAYBACK STANDBY or JOB mode.
Set the playback start point on the waveform.
Set the playback end point on the waveform.
Trim the waveform (remove unused parts at the ends of the waveform),
freeing up additional sample memory.
Reverse the direction of the waveform (so sound goes "backwards").
Adjust the dynamic range of the waveform.
Reduce the waveform's bit resolution (freeing up additional waveform memory).
Delete the sample (and all sequence data) from the selected track.
Resample from recorded track.
Resample from recorded song.
Load volume or sample from disk.
Save data to disk.
Delete volume from SCSI disk.
View amount of free memory on disk.
Format disk.
Set up the metronome.
Set the number of lead-in measures for song recording.
Set song recording mode to REPLACE or OVERDUB.
Set pad velocity sensitivity ON or OFF.
Select the input source for audio input.
Set the MIDI synchronization type for the current song.
Set the MIDI channel numbers for each track.
Set remote and local SCSI IDs.
Show remaining sequence or sampling.
Chapter 10 Jobs
Page
259
272
281
298
225