Sequencer Modes - Yamaha SU700 Owner's Manual

4.2 Sequencer Modes

This section briefly describes each of the four sequencer modes. You use these modes
to control song setup, recording, and playback. For practical information about how
to operate the sequencer during actual recording and playback, refer also to pages
162 to 165.
The table on page 145 shows the operations available from each of the sequencer
modes.
OVERVIEW
The general use for each of these modes is as follows.
PLAY STANDBY
PLAY
REC STANDBY
Lets you adjust the song location and set the knob settings,
mutes, effects, and tempo to be used for start of playback (or
recording). Also can be used to set up scenes and markers. Fi-
nally, you must also move through this mode when you want
to transition into job mode (to execute a job) or to sample-re-
cording mode (to record a sample).
Plays the song.
Lets you adjust the song location and set the environment for
start of recording. (You can adjust knob settings and mutes,
and you can recall any scene.)
Chapter 4 SU700 Operating Modes
Not moving
Advancing
Not moving
141