Connecting The Fm/Am Antennas - Yamaha DVX-S301 Owner's Manual

OTHER CONNECTIONS
TV IN terminal <E>
To listen to TV channels through this DVD receiver, use
the audio cables (white/red, not supplied) to connect the
TV IN jacks to the corresponding audio out jacks on your
TV.
Notes
– When using AV MONITOR OUT terminal to
listen to the TV channels, set the DVD receiver's
component setting to "RGB" (see page 25).
– When using TV IN terminal, set the DVD
receiver's component setting to"YUV" (see
page 25).
20

■ Connecting the FM/AM antennas

AM loop
antenna
1
FM wire
antenna
2
FM AM
GND
ANT ANT
TO SUBWOOFER
SYSTEM
IN
CONNECTOR
Ground (GND terminal)
For minimum interference, connect
the antenna GND terminal to a good
earth ground. A good earth ground
is a metal stake driven into moist
earth.
1 Connect the supplied AM loop antenna to the AM
ANT terminal. Place the AM loop antenna on a shelf
or attach it to a stand or wall.
2 Connect the supplied FM wire antenna to the FM
ANT terminal. Extend the FM wire antenna and fix its
ends to the wall.
For better FM stereo reception, connect an external
FM antenna (not supplied).
Notes
– Adjust the position of the antennas for optimal
reception.
– Position the antennas as far as possible from your
TV, VCR or other sources of radiation to prevent
unwanted interference.