Table 5-4 Advanced Airframe Specific Configuration Data - Arc Ranges - Garmin GI 275 Maintenance Manual

Table 5-4 Advanced Airframe Specific Configuration Data – Arc Ranges
Arc Color
RED Low speed
(LOW SPEED) awareness
Full flap operational
WHITE
range
Standard operational
HALF WHITE
range
Overlap between
WHITE/ standard operational
GREEN and flaps operational
ranges
Standard operational
GREEN
range
190-02246-11
Rev. 1
POH/AFM
Description
Section
2 - Limitations
2 - Limitations
2 - Limitations
2 - Limitations
2 - Limitations
If the aircraft has a defined WHITE or
GREEN arc, set the RED arc to ON. Set the
MAX value of the RED arc to the lowest
value of the WHITE or GREEN arc (Vs0). A
RED low-speed awareness arc will appear
below the lowest marked stall speed.
If the aircraft does not have defined white or
green arc, set the red arc to OFF, and enter
the lowest stall speed in the STALL SPEED
setting at the bottom of the page.
Set the Min value to the bottom of the POH/
AFM defined range.
If WHITE and GREEN arcs overlap, set the
Max value to the beginning of the WHITE/
GREEN arc.
If WHITE and GREEN arcs do not overlap,
set the Max value to the top of the POH/
AFM or aircraft specification defined range.
If a WHITE arc is not defined by the AFM/
POH or aircraft specifications, set both the
Min and Max values to the aircraft stall
speed in the landing configuration (Vs0).
This setting will not display a white arc, but
the system needs it to characterize aircraft
performance.
If the HALF WHITE arc range is not defined
by the AFM/POH or aircraft specification,
set to OFF.
This may sometimes be called a "narrow
WHITE arc".
If a WHITE/GREEN arc is not defined by
the AFM/POH or aircraft specification, set
to OFF.
If WHITE and GREEN arcs overlap,
configure to the range they overlap within.
If the GREEN arc is not defined by the
AFM/POH or aircraft specification, set to
OFF.
If WHITE and GREEN arcs overlap, set Min
value to the Max of WHITE/GREEN.
If the YELLOW arc is defined, set to the Min
of the YELLOW arc (Vno).
If the YELLOW arc is not defined, set Max
value to Vno/Vne.
GI 275 Part 23 AML STC Maintenance Manual
Notes
Page 5-40