Summary of Contents for Fisher & Paykel OR60SDBGFX2
Page 1
• Immediately wipe off any caustic cleaners if they are spilled onto the oven door handle. Wipe the outside surfaces often, using warm water and a mild household detergent. The stainless steel may also be cleaned with a suitable cleaner and polish. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR60SDBGFX2/User_Guide_OR60SDBGFX… Updated: Wed, 07 Oct 2020 12:30:37 GMT Powered by...
• Remember some foods, eg peas and swede, have a naturally high sugar content. Cleaning the inside of the oven • Do not use abrasive cleaners, cloths or pads to clean the enamel. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR60SDBGFX2/User_Guide_OR60SDBGFX… Updated: Wed, 07 Oct 2020 12:30:37 GMT Powered by...
Page 3
Make sure that the fixing screw is tightened and the element is held securely in place. • The grill element itself is self-cleaning. Fig.77 Drop-down grill element https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR60SDBGFX2/User_Guide_OR60SDBGFX… Updated: Wed, 07 Oct 2020 12:30:37 GMT Powered by...
Page 4
Bring to the boil and leave to soak for at least 30 minutes. Rinse the filter in clean water and dry. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR60SDBGFX2/User_Guide_OR60SDBGFX… Updated: Wed, 07 Oct 2020 12:30:37 GMT Powered by...
Page 5
2. Fit the sliding shelf support onto the top wire of a rack and press (Fig. 57). You will hear a click as the safety locks clip over the wire. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR60SDBGFX2/User_Guide_OR60SDBGFX… Updated: Wed, 07 Oct 2020 12:30:37 GMT Powered by...
Page 6
• both sides on the same level. Note: you cannot fit the sliding shelf supports to the top shelf position. Fig.80 Re tting the sliding shelf supports Fig.79 Removing the sliding shelf supports https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR60SDBGFX2/User_Guide_OR60SDBGFX… Updated: Wed, 07 Oct 2020 12:30:37 GMT Powered by...
• Fully open the lever “A” on the left and right hinges (Fig. 58b). • Gently close the door (Fig. 58c) until the left and right hinges are hooked to part “B” of the door (Fig. 58b). Fig.81a Fig.81b Fig.81c https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR60SDBGFX2/User_Guide_OR60SDBGFX… Updated: Wed, 07 Oct 2020 12:30:37 GMT Powered by...
Page 8
Fig. 82c) and remove it by pulling it out from the top clamps (arrow 2 in Fig. 82c). • Clean the glass with an appropriate cleaner. Dry thoroughly, and place on a soft surface. Fig.82b https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR60SDBGFX2/User_Guide_OR60SDBGFX… Updated: Wed, 07 Oct 2020 12:30:37 GMT Powered by...
Page 9
Fig.82a Fig.82c 4. Now you can also clean the inside of the outer glass. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR60SDBGFX2/User_Guide_OR60SDBGFX… Updated: Wed, 07 Oct 2020 12:30:37 GMT Powered by...
Page 10
(arrow 1 in Fig. 83b), then lower the pane and insert the bottom edge into the bottom clamps (arrow 2 in Fig. 83b); and then Fig.83a slide the pane into position (Fig. 83c). Fig.83b Fig.83c https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR60SDBGFX2/User_Guide_OR60SDBGFX… Updated: Wed, 07 Oct 2020 12:30:37 GMT Powered by...
Page 11
Make sure that you put it in the correct way (Fig. 84e). 4. Unlock the oven door by opening it completely and closing the lever “A” on the left and right Fig.84a hinges (Fig. 84d). Fig.84b Fig.84c https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR60SDBGFX2/User_Guide_OR60SDBGFX… Updated: Wed, 07 Oct 2020 12:30:37 GMT Powered by...
5. Withdraw the hinge hooks from their location following arrow “C” (Fig. 85e). 6. Rest the door on a soft surface. To replace the door, repeat the above steps in Fig.85a reverse order. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR60SDBGFX2/User_Guide_OR60SDBGFX… Updated: Wed, 07 Oct 2020 12:30:37 GMT Powered by...
4. Unscrew and replace the bulb “A” with a new one suitable for high temperatures (°300C) with the following specifications: 230-240V, 50Hz, E14 and same wattage as the bulb being replaced (check wattage stamped on the bulb). 5. Refit the protective cover “C”. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR60SDBGFX2/User_Guide_OR60SDBGFX… Updated: Wed, 07 Oct 2020 12:30:37 GMT Powered by...
• To remove the drawer, proceed as per Fig. 88. • To replace the drawer, repeat the steps in reverse order. Do not store flammable material in the drawer. https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR60SDBGFX2/User_Guide_OR60SDBGFX… Updated: Wed, 07 Oct 2020 12:30:37 GMT Powered by...
Page 15
Fig.87 Drawer Fig.88 Removing the drawer https://producthelp.fisherpaykel.com/nz/Cook/Freestanding_Cookers/Dual_Fuel/OR60SDBGFX2/User_Guide_OR60SDBGFX… Updated: Wed, 07 Oct 2020 12:30:37 GMT Powered by...