Panasonic GP-US932CSAE Operating Instructions Manual page 11

Note:
• When the REMOTE terminal is used, set Switch 4 to
"OFF" after turning off the power.
When Switch 4 is set to "OFF", button operations on
the front face are disabled.
!9 12 V DC power terminal [DC 12V IN]
This connector is used to connect an external DC
power supply of 12 volts (3 A or more).
Compatible connector (as of
April 2009):
HR10A-7P-4S (73) manufac-
tured by HIROSE ELECTRIC
CO., LTD.
@0 Remote terminal [REMOTE]
This port is used to perform external control.
(D-sub 9-pin connector,
female)
5 1
6
9
@1 S-video output connector [S-VIDEO]
This connector provides the luminance signal (Y) out-
put with synchronizing signal and color signal (C) out-
put.
Pin arrangement of
applicable connector
1 4
2 3
(Cable side)
Pin No. Signal
1 GND
2 TXD
3 RXD
4 DSR
5 GND
6 DTR
7 CTS
8 RTS
9 GND
@2 RGB/YPbPr connector [RGB/YPbPr]
This connector provides the RGB (red, green, and
blue) signal output or the YPbPr signal (luminance,
color difference B, and color difference R) output.
The output signal can be set up with use of "OUTPUT
SEL" in the SETUP menu. ( page 19)
(D-sub 9-pin connector,
male)
1 5
6 9
Pin No. Output signal
1 GND
2 GND
3 R, Pr
4 G, Y
5 B, Pb
6 VIDEO
7 SYNC
8 GND
9 GND
11