Operating External Units Connected With This System - Yamaha GX-90VCD Owner's Manual

OPERATING EXTERNAL UNITS CONNECTED WITH THIS SYSTEM

1,
MINI COMPONENT SYSTEM
GX–90VCD
VIDEO CD
Version 2.0 / Playback Control
1
2
3
PROGRAM
MUSIC
INPUT
ECHO ECHO
USER MEMORY
TAPE 1/2
REC/PAUSE
MODE
DOLBY NR
POWER
PHONES
TIMER REC
AUTO/MAN'L
TIMER
HOUR
1
PLAYBACK
EJECT
CD
1 2
1 2
6 7
6 7
A B
TIME PROG TAPE
MODE INDEX REPEAT
PREV NEXT
DISC SKIP
REC/PAUSE TAPE 1/2 PLAY
CENTER/REAR
TEST FLAT
/DELAY
ECHO/KEY
MUSIC
LEVEL
POWER
SLEEP
VOLUME
3, 2 2
1 1
DISC CHANGE
OPEN/CLOSE
VOLUME
CD
INPUT
NORMAL
Active Servo
HIGH Technology
DUBBING MIC MIXING
MEMORY
TIME ADJ
MIN
2
REC/PLAYBACK
EJECT
3, 2 2
3 4 5
3 4 5
8 PRESET
8 9 0
C D E
+
EDIT I0
TUNER
OPEN/CLOSE
RETURN SELECT
STOP PLAY
TAPE
PROGRAM USER
INPUT 1, 1 1
To listen to or watch a source on an
external unit connected with this
system
1
Press the INPUT selector
and select the position of input source (MD/AUX, VCR or
LD/TV) you will play back confirming it on the display.
* The names of input source positions correspond with
the names of terminals to connect with external units
on the rear of the main unit.
2
Play back the source.
(For a video source, turn the monitor TV on.)
3
Adjust the volume to a desired level by using the
VOLUME control.
If you prefer, use the graphic equalizer and/or the sound
field processor built into this system.
To record a source to tape
Not only a source played back on this system, but also a
source played back on an external unit can be recorded by
the built-in tape deck and/or a VCR, DAT, etc. connected
with this system.
* If you make a recording on the built-in tape deck, read
"General information" on page 41 before starting recording.
1 1
Select the source to be recorded by the INPUT selector
or button.
2 2
Play back the source and then turn the VOLUME control
up to confirm the input source.
3 3
Begin recording on the built-in tape deck or a VCR etc.
connected with this system.
* To make a recording on the built-in tape deck, follow
steps 3–7 on page 41.
To stop recording or to stop recording temporarily, also
refer to page 41.
Note
If the built-in graphic equalizer and/or sound field processor
is used, its effect is recorded along with the source when you
make recording on the following recording units.
● The built-in tape deck.
● The external recording unit connected to the MD/AUX
terminals on the rear of the main unit.
However, the effect of the graphic equalizer and/or sound
field processor cannot be recorded when you make recording
on the external recording unit connected to the VCR
terminals on the rear of the main unit.
E-43
or button once or more