Using The Menu - GE NetworX Series Manual

# "TO ACCESS MENU, ENTER [
for the other options.
# "ZONE BYPASS ACTIVE" - One or more zones are bypassed.
Check zone status.
# "SYSTEM TROUBLE, ENTER [
service condition. Consult your security system's user manual for
more information or call your installer.
# "POWER FAILURE" - Your system has lost electrical power.
# "LOW BATTERY" - Your backup battery has failed a system
battery test.
# "PHONE LINE TROUBLE" - Your system has detected a problem
with the phone line.
# "SYSTEM IS ARMED IN THE STAY MODE. ENTER CODE TO
DISARM. EXIT DOOR DELAY IS OFF."
armed in the INSTANT Mode. Refer to page 6 for details.
# "WHEN FINISHED, HANG UP" - Disconnect from the
"Operator" by hanging up.
Section II. U
When the "Operator" is on the line, the System Status will be stated. To
access the MENU for the various features of your system, press
The messages listed below are presented.
number for the desired MENU selection.
# "FOR ZONE STATUS, ENTER [0]" - For checking open/faulted
zones. Refer to page 8.
# "TO CHANGE AREA, ENTER [1]" - For changing the area.
# "FOR SYSTEM STATUS, ENTER [2]" –
armed/disarmed status of system. Refer to page 4.
# "FOR ALARM MEMORY, ENTER [3]" - For checking Alarm
Memory. Refer to page 12.
# "TO TEST SIREN, ENTER [4]" - For testing the siren.
ρ
]" - This takes you to the MENU
ρ
] [2]" – This will identify the
M
SING THE ENU
- Your system is
ρ
.
Press the appropriate
For checking