Checking System Status - GE NetworX Series Manual

From an off-site premise, you can also access the "Operator" using a
TouchTone telephone.
Step 1 Call the phone number of the protected site.
Step 2 When the phone is answered, press the pound key three
times within the first 8 seconds.
If a person or a device such as a fax/answering machine
answers the call, the "Operator" will come on the line when
the answering machine or person hangs up. Otherwise, the
"Operator" will automatically answer the call after a pre-
designated number of rings occur.
The "Operator" will prompt for a valid user code: "PLEASE
ENTER YOUR CODE".
Step 3 Enter your code. When it recognizes the valid user code, the
"Operator" will tell you the System Status including any
warnings, along with the various MENU choices.
FUNCTIONS OF THE "OPERATOR"
The "OPERATOR" has a wide variety of functions available to use in
controlling your security system by means of a TouchTone telephone.
Section I. C
System status is the first information you will hear when the "Operator"
comes on the line. This will inform you of the present status of your
security system. The messages given for System Status are as follows:
# "SYSTEM IS ARMED, ENTER CODE TO DISARM" - Enter your
code to DISARM.
# "SYSTEM IS READY, ENTER CODE TO ARM" - Enter your code
to ARM your system.
# "SYSTEM IS ARMED IN STAY MODE" – Your system is armed
in the STAY mode and provides exit delays.
# "SYSTEM NOT READY, PLEASE SECURE" – One or more zones
are not secure. Check zone status.
# #
S S
HECKING YSTEM TATUS
#