GE NetworX Series Manual page 12

When the "Operator" is on the line, perform the following steps to set
the TIME.
Step 1 Press ρ
The [ρ] accesses the MENU and [9] proceeds to the
OPTIONS menu, then [7] proceeds to the TIME section.
Step 2 "PLEASE ENTER YOUR CODE." Enter your user code.
Step 3 "ENTER HOUR FOLLOWED BY [#]."
For example, 2 o'clock would be
Step 4
"ENTER MINUTES FOLLOWED BY [#]."
For example, to set 18 minutes after the hour would be
1 8
Step 5
"ENTER [1] FOR AM. ENTER [2] FOR PM."
[1] for AM or [2] for PM.
Step 6 The "Operator" will automatically return to the MENU.
Section X. A
While your system is in the DISARMED state, the Alarm Memory section
of the MENU is accessed with these steps:
Step 1 Press ρ
The [ρ] accesses the MENU and [3] accesses the ALARM
MEMORY.
Step 2 The "Operator" will state the name of all zones that were
bypassed or faulted during the last alarm by stating one
of the following messages:
"ALARM, ZONE 1"
"ZONE 1 BYPASSED"
"FIRE, ZONE 1"
"FIRE TROUBLE, ZONE 1"
"TAMPER, ZONE 1"
If all zones were normal during last alarm, the
Step 3
"Operator" would state the System Status.
9 7 .
#
A M
CCESSING LARM EMORY
3 .
2 # .
Press