Using The Software For The First Time; Configuring The Connection To The Server - Xerox DocuColor 40CP Getting Started Manual

36 Installing User Software on a Windows Computer
Use the table below as a guide when installing Downloader and Print Calibrator. For
specific instructions, read the information in each dialog box.
Name of dialog box:
Welcome
Choose Destination Location
Select Program Folder
Start Copying Files
Information
Using the software for the first time
Before you can use the newly installed software, you must properly configure the
connection to the DocuColor 40 CP.
Configuring the connection to the server
The first time you use one of the utilities, you are prompted to configure the
connection to the DocuColor 40 CP.The same configuration is used for Downloader
and Print Calibrator, so any change in the configuration affects both of these.
B :
EFORE YOU BEGIN
• Print the Configuration page from the Control Panel and note the IP Address of the
DocuColor 40 CP.
You can also set up a Domain Name Server (DNS) for the IP address of the
DocuColor 40 CP in the printcap file and use that name. See your Windows system
documentation for information.
Action:
Read the Setup program
introduction.
Specify a hard disk location for the
installed utility software.
Specify a folder name for the utility
software located in the Programs
menu.
Verify the information in the
Current Settings area.
Acknowledge that the software
installation is complete.
When finished:
Click Next.
Click Next.
Click Next.
Click Next.
Click OK.