Border Erase - Xerox DocuColor 1632 User Manual

U G ( C
S E R U I D E O P I E R
Top & Bottom
Left & Right
1 – 4 4
)

Border Erase

The Border Erase feature enables you to eliminate unwanted
marks near the edges of the original from the output copy. The
range for Border Erase is 0 through 50mm in 1mm increments.
Border Erase offers the following options which can be used
individually or combined together:
For Normal the default is 2mm. For Variable Erase the default is
5mm.
For Normal the default is 2mm. For Variable Erase the default is
5mm.
Center The default is 0mm.
The selected settings are applied to both the front and back of 2-
sided copies.
When the image is reduced or enlarged, the selected percentage
will be applied to the Border Erase. For example, if Variable Erase
is set to 30mm, a 50% reduction will result in 15mm of border
erase on the output.
When making copies the copier always automatically adds a
Border Erase of 2mm to the top, bottom, left and right. This
cannot be eliminated.
1
On the Added Features tab select Border Erase.
2
Select Variable Erase.
3
Press the up or down arrows to increase or decrease the Border
Erase amount(s) for Top & Bottom, Left & Right, and Center.
4
Select the icon that most closely resembles the Original
Orientation for the loaded document(s).
5
Select Start to make copies or Save to select additional features.