Table of Contents
Advertisement
4.2 LOADING ROLL MEDIA
Please follow the procedure below to install and load roll media.
Make sure the printer and Unwinder/Winder 100 are switched ON.
Step 1 :
Raise the pressure rollers of the printer.
Step 2 :
Open the front cover
Step 3 :
Make sure both unwinder (REAR) and winder (FRONT) unit are set to MANUAL mode.
Step 4 :
Consider the specifications of the printer before loading media:
Step 5 :
Maximum loading capacity
Maximum media width
For Spitfire 65", Rockhopper 3 65" and Viper 65"
For Spitfire 90", Rockhopper 3 90" and Viper 90"
Minimum media width
For Spitfire 65", Rockhopper 3 65" and Viper 65"
For Spitfire 90", Rockhopper 3 90" and Viper 90"
Inner core diameter
Remove the packaging of the media roll.
Step 6 :
Check whether the media is inside or outside printable. This affects the installation method on the
Step 7 :
unwinder at the rear of the machine.
Install the media between the two roll units at the back of the machine. Loosen the handles to
Step 8 :
move the roll units left and right.
4-2
For ValueJet 1604
For ValueJet 1604
50.8 mm or 76.2 mm
Metrical
100 kg
1625 mm
1653 mm
2280 mm
1000 mm
210 mm
210 mm
Imperial
220 lb
63.98 in
65.07 in
89.76 in
39.37 in
8.27 in
8.27 in
2 in or 3 in
Advertisement
Table of Contents
