Table of Contents
Advertisement
4. If you suspect that the cause of the communications problem is the 49XX printer,
print out a Printer Setting page at the 49XX control panel and view the 49XX TCP/IP
parameters. See Appendix A.
If Dynamic IP Addressing is enabled. Try "hard coding" the 49XX IP address at the
If Dynamic IP Addressing is disabled. Verify the following settings on the Printer
NOTE: Any one of these important TCP/IP parameters (if set incorrectly) can cause
NOTE: Subnet Mask and Default Gateway are critical on multi network segment
NOTE: If you make any TCP/IP configuration changes, then the 49XX printer must be
5. If all of the above troubleshooting fails, you may have a malfunctioning NIC. Try a
Factory Reset at the 49XX control panel. Hard code IP address, Subnet mask, and
default Gateway at the 49XX printer. Reset the printer. Try "pinging" the 49XX
again. If the problem persists, call Xerox Technical Support for further instructions.
14-2
control panel. Reset the printer, and check for connectivity again with the ping
command.
Settings page with your local TCP/IP address administrator. This person should
be able to verify the correctness of the settings:
IP address
Subnet Mask
Default Gateway
TCP/IP communication problems.
LAN/WAN's.
reset for those changes to take effect.
XPrint UNIX SYSTEM PRINTER DRIVER INSTALLATION
Advertisement
Table of Contents
