Xerox PHASER 5400 User Manual page 13

If any of the following conditions occur, switch off the printer power immediately,


disconnect the power cord, and call an authorized service representative.
The power cord is damaged or frayed.


Liquid is spilled into the printer.


The printer is exposed to water.


Any part of the printer is damaged.


Maintenance Safety
Do not attempt any maintenance procedure that is not specifically described in the


documentation supplied with your printer.
Do not use aerosol cleaners. The use of supplies that are not approved may cause


poor performance and could create a dangerous condition.
Do not remove the covers or guards that are fastened with screws unless you are


installing optional equipment and are specifically instructed to do so. The power
cord should be removed when performing these installations. Except for user
installable options, there are no parts that you can maintain or service behind
these covers.
Operational Safety
Your printer and supplies were designed and tested to meet strict safety requirements.
These include safety agency examination, approval, and compliance with established
environmental standards.
Your attention to the following safety guidelines will help to ensure the continued safe
operation of your printer.
Use the material and supplies specifically designed for your printer. The use of


unsuitable materials may result in poor performance and possibly a hazardous
situation.
Follow all warnings and instructions marked on, or supplied with, the printer,


options and supplies.
Place the printer in a dust free, well ventilated area where the temperature range is


5 degrees C to 35 degrees C (41 degrees F to 95 degrees F) and the relative
humidity is 15 percent to 85 percent.
Place the printer in an area where there is adequate space for ventilation, operation


and servicing. The recommended minimal spacing is 76 cm (29.9 in.) in front of
the printer, 50 cm (19.7 in.) above the printer, 30 cm (11.8 in.) behind the printer,
20 cm (7.9 in.) on the side of the printer with the fan exhaust, and 10 cm (4.0 in.)
on the other side. Do not block or cover the slots and openings on the printer.
Without adequate ventilation, the printer may overheat.
For optimum performance, use the printer at elevations below 2,500 meters


(8,200 ft.). Use at elevations above 2,500 meters (8,200 ft.) exceeds operability
limits.
Do not place the printer near a heat source.


Do not place the printer in direct sunlight.


Do not place the printer in line with the cold air flow from an air conditioning


system.