Chiller Report - Trane ADAPTIVE CONTROL UCM-CLD Installation Operation & Maintenance

Chiller report

[operating mode] will be one of
Reset
Stopped by Local Display
Stopped by Remote Display
Stopped by Tracer
Stopped by External Source
Auto
Waiting, Restart Inhibit
Starting
Running
Running, Current Limit
Running, Condenser Limit
Running, Evaporator Limit
Stopping
Making ice
ice-making complete
Low ambient temperature lockout
Electronic expansion valve test
Manufacturing test
Service pumpdown
* Dashes will be displayed if the sensor is open
or shorted and neither outdoor air reset or
low ambient lockout is enabled.
** Dashes will be displayed if the zone
temperature sensor is open or shorted or
zone reset is disabled.
Chiller report: status, water temperatures and setpoints
Chiller
report
"Press (Next) (Previous) to continue"
Mode:
Request setpoint source:
Chiller Mode:
Request setpoint source:
Heat Mode:
Request setpoint source:
Compressors on
Circuits locked out
Making ice,
ice-making complete
Next
Active ice termination setpoint
Evaporator entering water temperature
Active chilled water setpoint
Evaporator leaving water temperature
Active hot water setpoint
Leaving water temperature
Evaporator entering water temperature
Evaporator leaving water temperature
Disable
Next
Condenser entering water temperature
Condenser leaving water temperature
Water heat recovery entering water temperature XXX.X C
Water heat recovery leaving water temperature
Active current limit setpoint
Chiller % Rated load amps
* Outdoor air temperature
** Zone temperature
Next
7
Next
Unit model
(service setting menu)
all others RTXA
[OPERATING MODE]
[SETPOINT SOURCE]
[OPERATING MODE]
[SETPOINT SOURCE]
[OPERATING MODE]
[SETPOINT SOURCE]
Next
A, B, C, D, NONE
CIRCUIT 1, CIRCUIT 2, NONE
Next
[Operating mode]
All others
Next
Next
Fan control
(Service Setting Menu)
Enable
Next
Next
XXX C
XXX.X C
XXX C
XXX.X C
XXX C
XXX.X C
XXX.X C
XXX.X C
XXX.X C
XXX.X C
XXX.X C
XXX %
XXX %
XXX.X C
XXX.X C