Table of Contents
Advertisement
About Operating Environments
Conditions for Installation Locations
This printer is designed for industrial use.
• Make sure that the room where you are using the machine is well ventilated. Otherwise a fire or
an electric shock might occur. Be sure to install a ventilator when installing the machine in a
sealed room or a room with poor ventilation.
• Do not place the machine in a humid or dusty environment. Doing so can result in fire or electric
shock.
• Do not obstruct the machine's vents. Doing so can result in fire as the internal components are
overheated.
The following is the recommended range for the operating environment:
• Temperature: 15–30°C (59–86°F)
• Humidity: 40–80%RH
• Altitude: 2,000 m (approx. 6,561.7 ft.) or less
Place the machine on a level surface. The machine must be level within 5 mm (approx. 0.2 inches): both
front to rear and left to right.
Place the machine in a stable place where the floor is strong enough to withstand a load of 1,800 N/m
more.
Avoid the following environments when locating the machine. If the machine is placed somewhere where
the conditions are different from those recommended, a failure may occur.
• Low temperature and humidity or high temperature and humidity
• Places exposed to direct sunlight
• Places close to heaters, air conditioners, or humidifiers
• Places subject to frequent strong vibration
• Places with poor ventilation
• Dusty areas
• Places close to an oil heater or machine generating ammonia, such as a diazo copy machine
Precautions for users of ultrasonic-type humidifiers
Do not use an ultrasonic-type humidifier near this product. Chlorine or mineral components atomized
by an ultrasonic-type humidifier may adhere to the electronic components inside the product, causing
it to malfunction.
About Operating Environments
or
2
7
Advertisement
Table of Contents
