Care And Troubleshooting; Routine Care - Minelab F3Ci Operation Manual

5.

Care and Troubleshooting

5.1

Routine Care

The F3Ci is designed for lasting use in harsh operating
environments. However, proper care and maintenance will ensure
long-term reliability. Key to ensuring the durability of the F3Ci is the
correct stowage of the detector whenever it is not in use. Additionally,
operators of F3Ci detectors should be aware of the following:
a. During rest periods, wherever possible, the detector should be
sheltered from direct sun, rain, snow etc.
b. On completion of operations, with the F3Ci fully extended, all
shafts should be wiped with a damp cloth to remove any dirt or
dust before collapsing the shafts.
c. Do not use solvents to clean the F3Ci. If any part of the detector
comes into contact with corrosive substances, wash the detector
with clean fresh water and dry with a clean cloth.
d. Ensure the F3Ci is dry before stowing in the Soft Carry Bag.
e. Ensure the batteries are removed from the Battery Compartment
before stowing the detector.
f. The Skid Plate is designed to protect the coil and may require
replacement after long periods of use. There is no requirement
to remove the Skid Plate to clean the inside during routine
maintenance. To replace the Skid Plate, remove the original using
fingers to lever it from the coil, then push the replacement Skid
Plate onto the coil (see Figure 25).
Figure 25: Replacing the Skid Plate
F3Ci Operations Manual
39