Dismantling The Control Cabling - Husqvarna 536LiP4 Workshop Manual

8.16 Dismantling the control cabling

NB! Use the CST to check the functions before
dismantling.
For products with S/N: -20180200001 (LiPX),
-20174600001 (LiP4), -20174600122 (LiPT5).
NOTE!
Note how wires, components, etc., are posi-
tioned before dismantling.
Make sure to position them correctly to avoid
pinching when the pole saw is reassembled.
1
Dismantle the control handle as described in
"6 Basic dismantle/assembly".
2
Dismantle the throttle trigger lock and throttle
trigger as described in "7.1 Dismantling the throttle
trigger lock and throttle trigger".
3
Dismantle the shaft and motor cabling as de-
scribed in "8.8 Dismantling shaft and motor
cabling (536LiP4/530iP4, 536LiPX/530iPX)"
and "8.10 Dismantling shaft and motor cabling
(536LiPT5/530iPT5)".
4
Lift out the main switch and disconnect the connec-
tor (B) and the wire (A),
Dismantle the keypad and its cabling.
NB! 8.13 Dismantling the main switch" for a de-
tailed description of disconnecting the contact
(C).
See figure 60.
5
Dismantle the connector on the control unit.
See figure 61.
• Use a flat sharp tool to carefully snap off the
bracket holder. See figure 61a.
• Carefully insert a small flat screwdriver be-
tween the silicone gasket and the control unit
frame. See figure 61b.
NOTE!
Make sure not to damage the silicone seal.
• Push the screwdriver lightly to loosen the
snap lock on the connector below the silicone
gasket.
Fig 60
Fig 61
Fig 61a
Fig 61b
34 – English
Repair Instructions
C
B
A