Husqvarna 536LiP4 Workshop Manual page 27

Repair instructions
8
Start at the saw head end to split the shaft.
Dismantle the screw inside the inner shaft.
Unscrew the stop screw holding the cabling in
place so it does not dislodge.
Pull out the cabling slightly and rotate it 180°
See figure 32.
9
Remove the sleeve inside the inner shaft on the
saw head and thread the cabling through the
sleeve.
See figure 33.
Pull apart the inner shaft from the outer shaft.
10
Continue with the battery housing end.
Dismantle the screw inside the lower part of the
shaft. Unscrew the stop screw holding the cabling
in place so it does not dislodge.
Pull out the cabling slightly and rotate it 180°
See figure 34.
11
Dismantle the clamp screws at the battery housing
end. Carefully bend the clamp away and remove it
from the shaft.
See figure 35.
12
Dismantle the screw holding the anti-vibration
elements.
See figure 36.
Separate the lower and upper parts of the shaft.
Dismantle the anti-vibration element.
13
Pull the cabling out of the shaft.
See figure 37.
Fig 32
Fig 33
Fig 34
Fig 35
Fig 36
Fig 37
27 – English