8.11 Assembling shaft and motor
cabling (536LiPT5/530iPT5)
1
Start with the cabling on the saw head side.
Thread the cabling through the inner shaft.
2
Thread the cabling into the sleeve holding the
cabling in place in the inner shaft.
See figure 38.
Fasten the sleeve in the shaft making sure it is
positioned correctly in the shaft.
3
Rotate the cabling 180° to fix it in the sleeve Lock
the cabling with a screw.
See figure 39.
4
Push the telephone cabling inside the outer shaft.
5
Make sure the inner shaft guides are positioned
correctly in the outer shaft.
6
Push in the inner shaft so that the cabling
protrudes from the other end.
See figure 40.
7
Assemble the clamp and its lock onto the outer
shaft. Tighten finger tight.
See figure 41.
8
Insert the anti-vibration element, making sure
the screw hole on the anti-vibration element
corresponds with the hole in the shaft. The anti-
vibration element has a guide ensuring it is
positioned correctly in the shaft.
Assemble the lower part of the shaft and screw
on the anti-vibration element and lower part of the
shaft.
Thread through the cabling.
See figure 42.
Fig 38
Fig 39
Fig 40
Fig 41
Fig 42
28 – English
Repair instructions