PRESONUS ATOM SQ Owner's Manual page 38

4 Advanced Ableton Live Integration
4.2 Screen Controls
4.2.1.2 Arpeggiator
5. Root. When selected, the Screen Encoder will change the Root note of a scale
(C, C#, D, D#, E, F, F#, G, G#, A, A#, B). The Root note is indicated by the green pads.
6. Velocity. When selected, the Screen Encoder will
toggle between three velocity modes:
• All. The pads can trigger all possible velocities from 1-127.
• Full. The pads will send a fixed velocity of 127.
• 16-vel. Only available when in Blocks or Continuous modes, 16-vel
takes a selected MIDI note from the top lane, and maps the selected
note across 16 possible fixed velocities in the bottom lane. Pad 1 is
fixed at a velocity of 7, and pad 16 is fixed at a velocity of 127.
1 2 3
Mode Swing Clear
Up 0% Sequence
Pad Configuration
Off 1/16 1
Arp Rate Octaves
6
4 5
Page up to get to Arp Mode options. Arp mode only stays engaged while on the
arpeggiator page.
1. Mode. When selected, the Screen Encoder changes
the Play Mode for the Arpeggitator.
• Up. The arpeggio starts at the lowest held note and travels upward through
the held notes, then returns to the lowest note as the arpeggio begins again.
• Down. The arpeggio starts at the highest held note and
travels downward through the held notes, then returns
to the highest note as the arpeggio begins again.
•
Up/Down. The arpeggio starts at the lowest held note,
travels upward to the highest, then travels back down to
the lowest note, and the arpeggio begins again.
•
Down/Up. The arpeggio starts at the highest held note,
travels downward to the lowest, then travels back up to
the highest note, and the arpeggio begins again.
• Random. The arpeggio plays the currently held notes in a random pattern.
•
Chord. The currently held chord (or single note)
is repeated as long as it is held.
• Input. The arpeggio pattern is derived from the
order in which notes are played and held.
2. Swing. When selected, the Screen Encoder will adjust the
amount of "Swing" that is applied to the sequence.
3. Clear Sequence. When pressed, stops a held sequence.
4. Arp. When pressed, toggles between the Arpeggiator's Off, On, and Hold modes.
ATOM SQ
Owner's Manual
36