PRESONUS ATOM SQ Owner's Manual page 23

3 Advanced Studio One Integration
3.2 Screen Controls
3.2.1.4 Pad Configuration
• Modwheel. The Touch Strip will be assigned to the Modulation Wheel
MIDI control with minimum value at the far left position and the maximum
value at the far right. While active, the modulation will stay in the last
position that was touched, indicated by the red LEDs above the strip.
•
Expression. The Touch Strip will be assigned to the Expression MIDI
control with the minimum value at the far left and the maximum value
at the far right. While active, expression will stay in the last position
that was touched, indicated by the red LEDs above the strip.
•
Breath CC. The Touch Strip will be assigned to the Breath MIDI
control with the minimum value at the far left and the maximum
value at the far right. Breath will stay in the last position that
was touched (indicated by the red LEDs above the strip).
•
Repeater (Note Repeat). The Touch Strip will use the 8 divisions (tall
white lines) to change the Note Repeat rate. From left to right: 1/4,
1/8, 1/16, 1/32, 1/4T, 1/8T, 1/16T, 1/32T. In this mode, all red LEDs will
remain lit indicating that the Touch Strip is controlling repeat rate.
•
Ch.Vol. The Touch Strip will be assigned to control
the currently selected track's volume.
• Control Link. The Touch Strip will be assignable to any
parameter using the Control Link function in Studio One.
2. +/-. Select to use the Screen Encoder to change the
plus and minus buttons assignment:
•
Pitchbend, plus pad will raise the pitch as more pressure is applied
and minus will lower the pitch as more pressure is applied.
• Breath/Mod, minus pad's pressure controls Modulation Wheel
and the plus pad's pressure controls the Breath MIDI control.
3. Note Repeat. When enabled, any note(s) played will repeat at the current Rate.
4. Rate. When selected, the Screen Encoder will change Note Repeat's rate.
5. Gate. Decreases or increases a note's repeat length.
6. Pressure. Enables or disables the ability to control note
repeat velocity with more or less pressure.
Page Up again to access the Pads configuration page. From here you can
set the layout modes of the pads, set the scale mode, and more.
1 2 3
Layout Scale Root
Keyboard Chromatic C
Pads
Synth Lead
Octave Range Full Vel.
0 0
6
4 5
1. Layout. When selected, the Screen Encoder will change how the layout of the
pads appear. Note that this feature is not available when using Impact XT.
• Keyboard. Follows the layout of a piano. White keys on the bottom lane
and black keys on the top lane. If a Scale type is selected (other than
ATOM SQ
Owner's Manual
21