Troubleshooting Calibration - Xerox CX PRINT SERVER 550 User Manual

22

Troubleshooting calibration

Resolve common troubleshooting problems that can occur during
the calibration process.
Message Recovery action
Values This message may appear after calibration
measurements are successfully measured. Clicking OK
collected
enables the calibration process to continue without any
during the
problem.
measurement
are not
monotonous.
The Eye-One Place the X-rite i1 back on its base in order to re-
calibrate it.
is not
calibrated.
Place it on
the base
and click
OK to
proceed.
The Make sure the i1 is connected correctly to the USB port
of the CX print server. When prompted, install the
software
driver.
cannot
identify
any
calibration
device.
Check that
a device is
connected
and that
you have
defined it.
Chapter 3—Calibration