Yaesu FT-450D Manual page 3

Hide thumbs Also See for FT-450D:

9. Disconnect the DC power cable and then remove the DB9 serial programming cable.

10. Thru the access hole on the bottom of the radio, move the program switch to the left, operate

position.

11. Reconnect the DC power.

12. Press and hold the Home/Recall button, and press the Power button to turn the FT-450D on

to reset the defaults. The FT-450D will show 7.000.00 MHz.

The updating process is now complete.

The firmware version can be displayed on the radio

While holding the MODE button

the window

0244.

Then turn the radio off and back on again for normal operation.

We hope this new firmware will increase your enjoyment of your FT-450D. Thank you for choosing

Yaesu radios. If you have any problems or questions, please contact Yaesu, Amateur Tech Support

amateurtech@yaesu.com.

Best regards,

Mikio Maruya, WA6F

Executive Vice President

Engineering & Customer Service

Yaesu USA

Yaesu USA | 6125 Phyllis Drive | Cypress, CA 90630 | 714.827-7600 | FAX: 714.827-8100

turn the radio on. The firmware version will be displayed in

http://www.yaesu.com