Table of Contents
Advertisement
Operation
8.6 faults
8.5.3
Re-commissioning the machine
When you re-commission the machine, proceed as follows:
● Study the record made when the machine was decommissioned, and reverse the
measures that were taken for conservation and storage.
● Perform the measures listed in the "Commissioning" section.
See also
Decommissioning the machine (Page 101)
Start-up (Page 81)
8.6
faults
8.6.1
Inspections in the event of faults
Natural disasters or unusual operating conditions, such as overloading or short circuit, are
faults that overload the machine electrically or mechanically.
Immediately perform an inspection after such faults.
Correct the cause of the fault as described in the respective remedial measures section.
Repair any damage to the machine.
8.6.2
Electrical faults
Note
If you are operating the motor with a converter, the operating instructions of the converter
must also be observed if electrical faults occur.
102
Operating Instructions, 03/2018, A5E41926185A
1MB155 / 1MB555
Advertisement
Table of Contents
