Table of Contents
Advertisement
Figure 66. Connecting the power switch and front USB cables
4. Replace the side channel by completing the following steps. Refer to the following figure.
a) Place the power switch and front USB cables against the outside of the system.
b) Put the side channel back into place, covering the cables. Ensure the tab at (A) is inserted into the
slot.
c) Secure the side channel to the chassis by using two screws at (B) and (C).
d) If the drive cables were moved, replace them.
76 Power Systems: Servicing the IBM Power System IC922 (9183-22X)
Advertisement
Table of Contents
