Changing Batteries - Windsor Walk Behind Scrubber 10052250 Operating Instructions Manual

5. Replace the battery caps, and leave them in
place while charging.
6. Unplug the battery connector from the machine.
FOR SAFETY: When charging, connect the
charger to the batteries before connecting the
charger to the AC wall outlet. Never connect the
charger to the AC wall outlet first. Hazardous
sparks may result.
7. Plug the charger connector into the battery
connector. Connect the charger AC plug to a
wall outlet. The charger gauge should indicate
that the batteries are charging.
8. When the batteries are fully charged, disconnect
the charger from the AC wall outlet, then
disconnect the charger from the batteries.
9. Connect the batteries to the machine connector.
10. Check the electrolyte level. It should be up to
the indicator ring. If necessary, add distilled
water.
11. Lower the battery cover.
Machines equipped with Onboard Charger:
1. Connect charger's AC power cord to AC mains.
The charger's YELLOW "AC" LED will light.
Note: When charger is energized, all machine
function will shut down.
2. Current level being delivered to the batteries will
be displayed on the charger's bar graph.
3. When battery charge level has reached 80% the
YELLOW "80%" LED will light.
4. Batteries will then receive a low current "finish-
charge" indicated by the flashing GREEN
"100%" LED.
5. Charging cycle is complete when "100%" LED is
continuously GREEN.
6. Disconnect charger's AC power cord.
7. Raise battery cover and check the battery
electrolyte level. It should be up to the indicator
ring. If necessary, add distilled water.
8. Lower the battery cover.
Note: For additional information about battery
charger function, please see the charger Product
Manual.

CHANGING BATTERIES

Stop the machine in a clean area next to the
charger. Turn off machine.
FOR SAFETY: Before leaving or servicing the
machine; stop on level surface, turn off machine
and remove key.
1. Raise the battery cover.
2. Disconnect battery pack from machine.
3. Use the proper size open end wrench to
4. Disconnect main positive lead and secure cable
5. Loosen both terminals on each jumper cable
6. Prepare a suitable site to place the batteries.
7. Attach suitable battery lifting device and lift
Batteries are a potential environmental hazard.
Consult your battery supplier for safe disposal
methods.
CUTTER 24V 86039070 04/10/07
disconnect main ground wire first and secure
cable terminal away from batteries.
terminals away from batteries.
and remove one at a time.
batteries from the machine.
! WARNING
+
RED
BLK BLK
-
-
+
RED
BLK RED
-
+
FRONT OF MACHINE
MAINTENANCE
-
+
RED BLK
RED
+
- -
BLK BLK
RED
+
4-5