Repositioning Or Removing The Power Supply Module - Trane PM014 Installation, Operation And Maintenance Manual

Installing the Power Supply Module

Repositioning or Removing the Power Supply Module

Follow these steps to reposition or remove the power supply module:
1. Perform the lockout/tagout procedures for line voltage power to the cabinet.
2. Insert a screwdriver into the DIN rail latch and gently pry upward with the screwdriver to
Avoid Equipment Damage!
Do not use excessive force. Excessive force could cause equipment damage.
Do not use excessive force. Excessive force could cause equipment damage.
3. While holding tension on the DIN rail latch, lift the module upward to remove or reposition.
4. If repositioned, push on the module until the DIN rail latch clicks back into place to secure the
.
Figure 4. Removing the power supply module
IMC pin connection
(two places)
DIN rail
12
disengage the clip.
module to the DIN rail.
NOTICE:
DIN rail
latch
DIN rail
groove
BAS-SVX33F-EN