Coil Status Registers (0X Register); Registers 00001 To 00018: Double Commands - Siemens SIPROTEC 7SJ80 Manual

1.3

Coil Status Registers (0X register)

1.3.1

Registers 00001 to 00018: Double commands

Register Designation of the SIPROTEC objects
00001 52 Breaker ON
00002 52 Breaker OFF
00003 <user-defined> ON
00004 <user-defined> OFF
00005 <user-defined> ON
00006 <user-defined> OFF
00007 <user-defined> ON
00008 <user-defined> OFF
00009 <user-defined> ON
00010 <user-defined> OFF
00011 <user-defined> ON
00012 <user-defined> OFF
00013 <user-defined> ON
00014 <user-defined> OFF
SIPROTEC Modbus - Bus mapping 7SJ80/7SK80/7RW80
C53000-L2240-A320-3
The Coil Status register block allows the Modbus master to scan
• command outputs through the output relays of the devices (external commands),
• manipulation of taggings (internal commands) that can be changed using Modbus.
Furthermore, these registers can be used to execute switching operations and internal
commands.
Note:
• The allocation of the output relays to the switching devices and to the output
channels is defined during the parameterization of the SIPROTEC devices.
• Depending on the device composition, there may be less than indicated output
relays (and corresponding Modbus registers) available in the SIPROTEC device.
• User-defined double commands with double-point indications as checkback
indication can be routed on these positions as a "Source/destination system
interface" using the DIGSI Configuration matrix.
• Please observe the information in the chapter "Double commands/double-point
indications" of the "SIPROTEC communication modules, Modbus - Communication
profile" manual (ref. to page 3).
Comment
52 Breaker
not pre-allocated
not pre-allocated
not pre-allocated
not pre-allocated
not pre-allocated
not pre-allocated
Modbus Register Map Organization
Internal
object
no.
-
-
-
-
-
-
-
17